Titebond II Premium 3.7L - Professional Waterproof Wood Glue D3

Titebond II Premium is a one-component, cross-linking dispersion adhesive based on PVAC. It is recommended for cold or hot bonding, in presses, and for finger joints. The advantages of this glue include a short setting time, viscosity stability, and a relatively high solids content. Titebond II can be used for both outdoor and indoor projects and meets the European DIN EN 204 standard for water resistance - D3.

Advantages:

Fast bonding speed and excellent joint strength
Ideal for both outdoor and indoor woodworking projects
D3 water resistance
Open time: 3-5 minutes and short clamping time: 10-20 minutes (at 20°C)
Easy to spread
Non-toxic
Easy to clean with water

Capacity: 3.7L

Made in the USA

PHYSICO-CHEMICAL PARAMETERS

Chemical base: Polyvinyl acetate (cross-linking)
Color: white (transparent when dry)
Density (g/cm³): 1.09
Solids content (%): 49-50
Viscosity (mPas): 3,000 - 4,300
Suggested minimum application temperature: 15°C
pH: 2.0-3.3
Freeze-thaw stability: yes

APPLICATION INSTRUCTIONS

Material moisture: The moisture content of the material should be 6-10%. Excessive moisture significantly increases the bonding time.

Material preparation: The material should be prepared and glued on the same day. Ensure the bonding surfaces are flat and free from wood dust and debris.

To achieve even pressure distribution during bonding, the thickness difference of the bonded material should not exceed ± 0.15 mm. Maximum deflection of bonded material: 1.5 mm.

Application: The typical application amount is 120-150 g/m². For porous or uneven surfaces, this amount may need to be increased.

Open time: 7-10 minutes, depending on the amount of adhesive applied, porosity of the material, wood moisture, bonding temperature, and other factors.

Pressing pressure: The pressing pressure mainly depends on the wood species. Recommended values are: for softwood: 7.0-10.5 Kg/cm²; medium-hardwood: 8.8-12.3 Kg/cm²; hardwood: 12.3-17.6 Kg/cm².

Pressing time: 10-20 minutes (at 20°C), depending on wood species, moisture, and bonding temperature.

Post-bonding: After removing the piece from the press, the joint achieves initial strength sufficient for handling. Mechanical processing is recommended the following day to avoid dimensional changes in the glued material due to residual moisture in the joint.

Cleaning: Use cold water to remove wet glue. For partially dried glue, use hot water. For fully dried glue, the best results are achieved with hot steam. To prevent adhesive buildup on equipment and tools, an anti-adhesive agent is recommended.